Mileage
226,483
Service Date
7/26/2023
Services Performed
- ENGINE CUTTING OUT WHILE DRIVING ESPECIAL UP HILL SHUTS OFF, ALL CODES READ ECM P0335 CRANKSHAFT POSITION SENSOR CIRCUIT "A" TPMS C1332 SENSOR 1 FAULT C1334 SENSOR 3 FAULT C1126 TPMS ECU BATTERY VOLTAGE LOW C1312 SENSOR 1 RADIO FREQUENCY FAILURE C1314 SENSOR 3 RADIO FREQUENCY CHANNEL FAILURE TESTED CRANK SENSOR UP TO PCM ALL INSPEC NOW. FIRST STEP REPLACE SENSOR
- FRONT PADS ARE AT 3MM REAR PADS ARE AT 1.5MM MINIMAL THICKNESS IS 3MM
- ROAD TEST BEFORE AND AFTER, ADVISE AND NOTE ON ANY WARNING LIGHTS ON OR NOISES, ADVISE AND NOTE ON OIL LEAK"S" CHANGE ENGINE OIL AND OIL FILTER, CHECK AIR FILTER AND ADVISE, CHECK AND TOP OFF ALL FLUID LEVELS. CHECK ALL HOSES AND BELTS AND ADVISE, CHECK LIGHTS AND ADVISE, CHECK TIRE AIR PRESSURE AND SET TO MANUFACTURE SPECS, SAFETY CHECK UNDER CAR. ADVISE ON FURTHER REPAIRS AS SEEN. RESET OIL CHANGE LIGHT. CHECK FOR ALL OIL LEAKS, AND ADVISE.
- PULL OFF THIRD BRAKE LIGHT HOOK UP WASHER HOSE
- DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
- DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
- FLUSH HYDRAULIC BRAKE SYSTEM WITH 24OZ OF VALVOLINE PROFESSIONAL SERIES FLUID, USING VALVOLINE BRAKE FLUSH MACHINE. INSTALL SUPPLIED BLEEDER CAPS ONTO CALIPERS AND CLEAN.
- CRANKSHAFT POSITION SENSOR – Remove & Replace
TAMELA B. gave our service a 5 star review on 7/27/2023