Services Performed
- Instrument cluster codes B1318 – Battery Voltage low U0100 – Missing comms with PCM U2013 – Compass module no response B2103 – PATS transceiver circuit error B1600 – AT certain time since last clear the ignition was switched on without any key code being read B1602 – AT certain time since last clear a PATS key used has not been read correctly U2511 – CAN communication bus error U2472 – Unexpected ignition status Restraint module codes U0253 – Missing comma with APIM PCM codes P0365 – Cam position sensor B circuit Bank 1 P0369 – Cam position sensor B Circuit intermittent Bank 1 P0390 – Cam position sensor B circuit Bank 2 P0394 – Cam position sensor B circuit intermittent Bank 2 Upon first fire up of engine, sounded very loud and starved of oil. 1st tip for codes states to check oil level of system as it can directly affect camshaft performance of VCT vehicles. Checked oil at dipstick and there was no reading. Between draining the oil pan and engine oil filter, only 2qts was recovered from the entire system (7qt capacity system) Thicker oil recommended as well as regular checks of dipstick oil level to prevent catastrophic engine failure. ROAD TESTED VEHICLE MULTIPLE TIMES AFTER PERFORMING OIL CHANGE AND AFTER ABOUT 15 MINUTES OF DRIVING IT WILL SET CODES FOR CAMSHAFT B SENSOR. TRIED TO INSTALL NEW SENSOR AND OVERLAY, CODE STILL COMES BACK. FOUND CAM TONE RING WALKING WHEN ENGINE GETS HOT.
- ROAD TEST BEFORE AND AFTER, ADVISE AND NOTE ON ANY WARNING LIGHTS ON OR NOISES, ADVISE AND NOTE ON OIL LEAK"S" CHANGE ENGINE OIL AND OIL FILTER, CHECK AIR FILTER AND ADVISE, CHECK AND TOP OFF ALL FLUID LEVELS. CHECK ALL HOSES AND BELTS AND ADVISE, CHECK LIGHTS AND ADVISE, CHECK TIRE AIR PRESSURE AND SET TO MANUFACTURE SPECS, SAFETY CHECK UNDER CAR. ADVISE ON FURTHER REPAIRS AS SEEN. RESET OIL CHANGE LIGHT. CHECK FOR ALL OIL LEAKS, AND ADVISE.
DAVID & DEBORAH S. gave our service a 5 star review on 10/11/2025