2007 Chevrolet Silverado
Mileage
206,882
Service Date
6/15/2021
Services Performed
- BALL JOINT – Remove & Replace – 2500 HD,3500 HD,4WD Lower,Both – [DOES NOT include alignment.]
- IDLER ARM – Remove & Replace – 2500 HD,3500 HD w/Skid Plate – [DOES NOT include alignment.]
- TIE ROD &/OR END – Remove & Replace – 2500 HD,3500 HD,Recirculating Ball Type Gears Inner,Both – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of
- AXLE SHAFT – Remove & Replace – 2500 HD,3500 HD One Side – [Independent Suspension. NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of
- STEERING GEAR (COMPLETE) – Remove & Replace – 2500 HD,3500 HD,Diesel Worm & Ball Nut Type Gears – [Includes: Manual and Power Rack & Pinion, Worm & Ball Nut and Rack & Piston Assemblies. Adjust Toe-in on Rack & Pinion models. DOES NOT include transfer of
- DRAIN OUT POWERSTEERING FLUID. ADD BG CLEANER INTO SYSTEM AND ROTATE STEERING WHEEL LEFT AND RIGHT WHILE SUCKING OUT AND ADDING CLEANER. AFTER ALL CLEANER IS USED, INSTALL BG POWER STEERING FLUID. ROADTEST VEHICLE AND RECHECK FOR LEAKS.
- WHEEL ALIGNMENT
- PROPELLER SHAFT – Remove & Install or Remove & Replace – One Piece Driveline,To Rear Axle
- build drive shaft
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – 2500 HD,3500 HD Both – [DOES NOT include disassemble or alignment (where applicable).]
- SHOCK ABSORBER – Remove & Replace – Both
ALVIN P. gave our service a 5 star review on 6/15/2021