ROAD TEST BEFORE AND AFTER, ADVISE AND NOTE ON ANY WARNING LIGHTS ON OR NOISES, ADVISE AND NOTE ON OIL LEAK"S" CHANGE ENGINE OIL AND OIL FILTER, CHECK AIR FILTER AND ADVISE, CHECK AND TOP OFF ALL FLUID LEVELS. CHECK ALL HOSES AND BELTS AND ADVISE, CHECK LIGHTS AND ADVISE, CHECK TIRE AIR PRESSURE AND SET TO MANUFACTURE SPECS, SAFETY CHECK UNDER CAR. ADVISE ON FURTHER REPAIRS AS SEEN. RESET OIL CHANGE LIGHT. CHECK FOR ALL OIL LEAKS, AND ADVISE.
MARK S. gave our service a 5 star review on 4/29/2024
ROAD TEST BEFORE AND AFTER, ADVISE AND NOTE ON ANY WARNING LIGHTS ON OR NOISES, ADVISE AND NOTE ON OIL LEAK"S" CHANGE ENGINE OIL AND OIL FILTER, CHECK AIR FILTER AND ADVISE, CHECK AND TOP OFF ALL FLUID LEVELS. CHECK ALL HOSES AND BELTS AND ADVISE, CHECK LIGHTS AND ADVISE, CHECK TIRE AIR PRESSURE AND SET TO MANUFACTURE SPECS, SAFETY CHECK UNDER CAR. ADVISE ON FURTHER REPAIRS AS SEEN. RESET OIL CHANGE LIGHT. CHECK FOR ALL OIL LEAKS, AND ADVISE.
EUGENE W. gave our service a 5 star review on 4/10/2024
FOUND CODES P06C9- CYLINDER 5 GLOW PLUG INCORRECT. P06CA- CYLINDER 6 GLOW PLUG INCORRECT. P133C- CYLINDER 5 GLOW PLUG OFFSET EXCEEDED LEARNING LIMIT. PERFORMED TEST ON GLOW PLUGS AND FOUND GLOW PLUGS FOR CYLINDERS 5&6 TESTING AT .5OHMS AND ALL OTHER GLOW PLUGS TESTING AT 1.2OHMS. RECOMMEND ALL GLOW PLUGS TO SAVE MONEY ON LABOR. FOUND CODE P24C7- PARTICULATE MATTER SENSOR TEMPERATURE PERFORMANCE. PERFORMED FLOW CHART FOR P24C7 AND TEST LED US TO A FAULTY SENSOR.
PERFORMED FLOW CHART AND USED OUR TRAILER SIMULATOR ON TRUCK AND FOUND ALL TRAILER BRAKE CONNECTIONS FROM TRUCK WORK. CHARGING VOLTAGE AND TRAILER BRAKE AMPERAGE ALL ARE WITHIN SPEC. CODE DOES NOT RESET WHEN USING TRAILER BRAKES WITH SIMULATOR. NEED TO HAVE TRAILER INSPECTED FOR WIRING PROBLEMS.
FOUND HIGH PRESSURE AC SWITCH WIRES CHEWED FROM RODENTS. CONNECT WIRES AND TEST AC SYSTEM.
BRANDON O. gave our service a 5 star review on 3/28/2024
FOUND FUEL SYSTEM LOST ITS PRIME. FUEL FILTER HOUSING DOES NOT SHOW ANY SIGNS OF LEAKING. FUEL GAUGE IS SITTING JUST UNDER 1/4 TANK. PUMPED FUEL FILTER HOUSING 10 TIMES AND VENTED AIR TRAPPED IN SYSTEM, ENGINE RUNS. RECOMMEND DROPPING TANK TO SEE IF SENDING UNIT IS FAULTY AND TRUCK IS OUT OF FUEL. IF TRUCK IS OUT OF FUEL RECOMMEND NEW SENDING UNIT, IF TRUCK HAS 1/4 TANK RECOMMEND INSTALLING AIR DOG. CUSTOMER WANTS TO INSTALL NEW FACTORY FUEL FILTER HOUSING AND RELEASE TRUCK.
STEERING GEAR (COMPLETE) – Remove & Replace – 2500 HD,3500,6.6L Eng Worm & Ball Nut Type Gears – [Includes: Manual and Power Rack & Pinion, Worm & Ball Nut and Rack & Piston Assemblies. Adjust Toe-in on Rack & Pinion models. DOES NOT include transfer of c
FREIGHT
DRAIN OUT POWERSTEERING FLUID. ADD BG CLEANER INTO SYSTEM AND ROTATE STEERING WHEEL LEFT AND RIGHT WHILE SUCKING OUT AND ADDING CLEANER. AFTER ALL CLEANER IS USED, INSTALL BG POWER STEERING FLUID. ROADTEST VEHICLE AND RECHECK FOR LEAKS.
FRONT PADS AT 4MM AND REAR PADS BRAND NEW. WILL NEED FRONT PADS AND ROTORS NEXT OIL CHNAGE.
ROAD TEST VEHICLE TO CHECK STEERING ANGLE/PULL. CHECK TIRE PRESSURE. CHECK BALL JOINTS AND STEERING LINKAGES FOR WEAR. CHECK HEIGHT OF VEHICLE. ADJUST CAMBER, CASTER AND TOE ANGLES.
PATRICK O. gave our service a 5 star review on 3/6/2024
Upon removal of driveshaft, found carrier assembly rubber isolator to be completely detached from rest of unit.
ROAD TEST BEFORE AND AFTER, ADVISE AND NOTE ON ANY WARNING LIGHTS ON OR NOISES, ADVISE AND NOTE ON OIL LEAK"S" CHANGE ENGINE OIL AND OIL FILTER, CHECK AIR FILTER AND ADVISE, CHECK AND TOP OFF ALL FLUID LEVELS. CHECK ALL HOSES AND BELTS AND ADVISE, CHECK LIGHTS AND ADVISE, CHECK TIRE AIR PRESSURE AND SET TO MANUFACTURE SPECS, SAFETY CHECK UNDER CAR. ADVISE ON FURTHER REPAIRS AS SEEN. RESET OIL CHANGE LIGHT. CHECK FOR ALL OIL LEAKS, AND ADVISE.
2mm front pads, rotors lipped and hot . 8mm rear pads, rotors in a little better condition than fronts
DISC ROTOR – Remove & Replace – 2500 HD Front,Both – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
FLUSH HYDRAULIC BRAKE SYSTEM WITH 24OZ OF VALVOLINE PROFESSIONAL SERIES FLUID, USING VALVOLINE BRAKE FLUSH MACHINE. INSTALL SUPPLIED BLEEDER CAPS ONTO CALIPERS AND CLEAN.
REPLACE CENTER SUPPORT, ALL UNIVERSALS AND BALLANCE
DOUG F. gave our service a 5 star review on 2/13/2024
PRESSURE TEST SYSTEM NOT LEAKING AT THIS TIME JUST OLD SIGNS. BLOCK CHECK FOR HYDRO CARBONS IN RADIATOR CLEAR, ENGINE OIL IS CLEAR AND FILL CAP IS CLEAR., THIS IS FIRST SIGNS OF ENGINE OIL COOLER LEAKING. FIRST STEP IS WATER PUMP NEW THERMOSTAT AND RADIATOR CAP THEN RETEST
THERMOSTAT HOUSING – Remove & Replace – 1.8L Eng – [Includes: R&I Battery and Tray.]
NEIL H. gave our service a 5 star review on 1/10/2024
ecm p0101-00 mass air flow sensor performance p154a-00 intake heater feedback circuit gpcm p0101-00 mass air flow sensor performance p154a-00 intake air heater feedback circuit ebcm u0140-00 lost communication with bcm. FOUND INTAKE HEATER NOT PLUGGED IN ALL THE WAY, AIR FILTER PLUGGED AND INTAKE AIR CHAMBER OFF. REPLACE CLEAR CODES AND RODE TEST OK AT THIS TIME
ERIC P. gave our service a 5 star review on 12/2/2023